Safe operation rules for metal mold processing
Safe operating procedures for hardware processing:
1, hardware processing, the operator should maintain the correct posture, enough spirit to cope with the work. When operating, the mind should be focused, can not chat, cooperate with each other, the operator should not be agitated, fatigue state of operation, in order to ensure personal safety, avoid accidents, ensure the safety of operation. All staff should check whether their clothes meet the job requirements before going on duty. Don't wear slippers, high heels and unsafe clothing. Wear a hard hat if you have long hair.
2. Check whether the oil is added before the mechanical action, and check whether the clutch and brake are normal. The machine is airlifted for 1-3 minutes, and it is forbidden to use the machine when it is faulty.
3. When the starting power starts the machine, it must wait for others to leave the mechanical workspace and remove the sundries on the workbench before it can start.
4. When the machine is working, it is not allowed to reach into the working area of the slider, and it is strictly prohibited to take and release the work piece by hand. When putting out parts in the die, the tool must be used in accordance with the standard. If the machine appears abnormal sound or machine failure, should immediately turn off the power switch for inspection. After starting the machine, one person shall carry materials and operate the machine. Other personnel shall not press the pedal switch board or pedal switch board, nor shall they put their hands into the mechanical work area or touch the moving parts of the machine with their hands. For the purpose of safety of others, hands shall not be placed in the mechanical work area.
5. First cut off the power supply when changing the die. Only after the press movement department stops working can the installation and debugging of the die begin. After loading and adjusting, move the flywheel twice for test punching to avoid unnecessary collision between the processed product and the machine. The upper and lower die must check whether it is symmetrical and reasonable, whether the screw is firm, and whether the position of the blank holder is reasonable.
