The Use Of Mold Drawing For Hardware Mold Processing

Nov 04, 2022

Leave a message

The use of metal mold processing drawing mold drawing

In the process of mold processing, it is necessary to follow the prescribed process in order to ensure the accuracy of the mold and product quality. Mold processing is a complex process, in the processing of the process must be accurate.

    _

Drawing mold drawing of hardware mold processing:


1.  When adjusting the finished drawing, the finished drawing must be multiplied by the shrinkage. (Mold size = product size × shrinkage) the finished product drawing must be mirrored once, that is to say, the finished product drawing is mirrorized (except the finished product is completely symmetric) in the front mold, the lines that do not belong to the front mold should be removed, and the lines that do not belong to the back mold should be trimmed.


2.  The finished product in the mold should abide by the principle of division, especially the symmetry, such as the finished product is not divided, to the factory processing is likely to have problems.


3.  All the mold pillow position, pillow position must avoid water, can not avoid to add water.


4. The distance between finished products 12-20mm(in special cases, can do 3mm) when entering the water, there should be enough diving position, finished products to the CORE side 15-50mm, the distance between finished products and the CORE end is related to the forming surface of the product, general products can be selected by referring to the empirical value.


Send Inquiry