Points for attention in stamping die assembly

Mar 21, 2023

Leave a message

Points for attention in stamping die assembly

 

(1) First install the upper and lower die base of the stamping die, the upper die base is installed on the slide block of the punch or press, and the lower die base is installed on the bench surface of the punch or press. After the upper and lower die seats are fixed, the mold parts are installed on the die seats, which can ensure the correct and accurate installation position, in order to prevent the error from causing the failure to work.

 

(2) At the same time, when installing the concave and convex die, there should be even blanking space between them, so as to ensure the stamping quality and extend the service life of the stamping die. In addition, the assembly sequence of the upper and lower molds should be determined according to the mold structure. Different installation methods should be determined for the mold installation with guide posts and without guide posts.

 

(3) For complex stamping die installation, it is necessary to determine a reasonable assembly sequence according to the size of the upper and lower die parts installation restrictions. Improper installation sequence can sometimes affect the subsequent installation work, or the installation cannot occur. So the correct installation sequence is also very important.

Send Inquiry