How to prevent punching waste from jumping back
In stamping processing, we should prevent the punching waste from jumping back or falling to the material is not smooth and other problems. It will affect the quality of the surface of the stamping parts, and may also enter the last process, resulting in bad stamping products and affecting the use of the die.

The cause of the waste bounce and the life of the solution.
1, vacuum adsorption: in the stamping material is soft, extrusion plastic deformation, often make the top of the punch and waste extrusion into a vacuum state, this vacuum state is there is a certain adsorption force, also often punching waste out of the surface of the die, causing the waste to jump back.
2, oil film adhesion: in order to make the convex and concave die have good lubricity in the process of high-speed stamping, reduce the metal adhesion caused by the high-speed friction between the convex and concave die and the stamped material, the sliding part of the punching die and the punching strip are often taken to add lubricating oil measures. Lubricating oil can bring good lubrication effect, but it will also produce an oil film adhesion effect between the top of the punch and the punching waste. Especially for the stamping process of soft and thin materials, the waste will often jump back because of the oil film adhesion.
3, magnetic adsorption: after grinding the upper die of the punching die, because there is no repeated demagnetization operation procedure, the upper die of the punching die has a strong magnetic adsorption force. When the micro-hole high-speed stamping processing material is silicon steel sheet and other magnetic adsorption materials, it will bring out the punching waste due to the magnetic adsorption force of the upper die of the punching die, causing the waste to jump back.
4, the waste packaging caused by punch passivation: when the stamping reaches a certain number of times, the punch edge will produce passivation phenomenon, the edge is no longer sharp, but into a small R rounded corner, will produce extrusion and deep deformation of the waste packaging phenomenon with the punching waste, the waste has a blunt punch to form a package clamping force, punching waste will also be with the punch out of the die surface, Causing the waste to jump back.
