Cleaning Of Molds

Nov 13, 2022

Leave a message

Cleaning of molds

The maintenance of the die has very important significance for its good state, ensuring the quality of stamping parts, avoiding accidents, extending its service life and ensuring the normal operation of production.

At the same time, in the cold stamping production, through the implementation of a set of practical use, preventive maintenance and repair of the die organization measures, not only can improve the durability and precision of the die, so that it can be in a long time in a good technical state and performance, but also to ensure the quality of stamping products, reduce the cost of stamping parts effective way.

Next, let's understand one of the mold maintenance items: mold cleaning and maintenance.


    1_

Cleaning of molds

In order to ensure the quality of stamping parts and prolong the life of the die, it is necessary to clean and clean the die.

1. Daily cleaning

1) Dust on the surface of the mold: After wiping with a clean rag, touch the surface of the mold with your hand. If you can't feel the dust, it is considered qualified.

2) Cleaning of mold guide sleeve and guide column: wipe the oil stains on the guide column, guide sleeve and guide block with a rag, and then apply a small amount of lubricating oil.

3) Cleaning of punching parts: use a hammer to remove all the waste materials in the hole and the waste materials stuck on the sliding material plate and the scraps cut at the cutting edge.

4) For coated molds, the drawing surface of the molds must be cleaned, and the surface must be determined by hand. The first material in production must be wiped clean with a rag. The mould must be lightly oiled after production.

2. Clean regularly

1) After mold maintenance, the surface of the mold must be cleaned.

2) Every once in a while, all the molds must be decomposed, and then all the products must be cleaned.

3) In the process of regular maintenance, the outer surface of the mold, disassembly and replacement of parts, and thorough cleaning.

4) Before mold installation, clean the upper and lower surfaces of the mold to ensure that the mold installation surface and the working surface of the press are not damaged by compression and the parallelism of the upper and lower installation surface of the mold in production.

5) After the mold is installed, the mold will be opened, and the parts of the mold will be cleaned, especially the guiding mechanism. For the surface parts of the mold, the surface of the mold will be cleaned to ensure the quality of the parts.


Send Inquiry