Metal stamping die use maintenance and maintenance
1. When the mold is not in use, anti-rust oil should be applied to the working part in time. When using the mold, the oil should be wiped clean first, and the oil absorbent paper should be used for test stamping until the oil is absorbed clean, otherwise, the quality of electroplating will be affected.
2. When the mold is moving, it should be light, stable and slow to avoid impact and fierce vibration.
3. The cutting edge must be ground after using the mold for a long time, and the cutting edge surface must be demagnetized after grinding, otherwise it is easy to block material.
4. In the process of use, the punch is easy to break, bend and chew the phenomenon, and the punching sleeve is generally chewed. The damage of punch and punch sleeve is usually replaced with parts of the same specification.
5. Spring elasticity is easy to be damaged in the process of use, usually resulting in fracture and deformation. The way to take is to replace, in the process of replacement must pay attention to the specifications and models of the spring, the specifications and models of the spring through the color, outside diameter and length of three to confirm, only in the case of the three are the same can be replaced.
6. During maintenance, it is necessary to check the relationship between the parts and whether there is any damage, repair the damaged parts, and take measures for the specific situation. If the air pipe is damaged, replace it.
7, fastening parts, check whether the fastening parts loose, damage phenomenon, need to use the same specification of parts for replacement.
