Excellent stamping die technology is guaranteed

Apr 10, 2021

Leave a message

The closing height of the die refers to the distance H between the upper plane of the upper die seat and the lower plane of the lower die seat when the slider is at the bottom dead center, that is, when the die is working at a low level. The closing height of the die must be compatible with the height of the press. The installation height of the press is the distance between the lower end of the slider and the plane of the backing plate when the slider is at the bottom dead center. When the connecting rod is adjusted to a short time, it is the high mold mounting height of the press; when the connecting rod is adjusted to a long time, it is a small mold mounting height.

The closing height H of the die should be between the high die height Hmax of the press, and the relationship is: if the closing height of the die is greater than the die height of the press, the punch cannot be used on the press. On the contrary, when the height of the small mounting die of the press is less than the height of the press, the other shape and structure dimensions of the die that can be added with a flat backing plate must also be compatible with the press. For example, the contour plane size of the die and the bottom surface size of the backing plate of the press and the slide block. The size of the shank and the shank hole, the plane size of the lower mold buffer and the size of the press backing plate hole must be adapted so that the mold can be installed correctly and used normally


Send Inquiry