product description
First introduce the mold structure of the safety shoe steel toe cap. Its structure is quite special. The difference from the traditional mold structure is that it can be stretched as a whole. The 6 mm wool must be removed in the middle, and then it is trimmed and molded. The service life is 300,000 strokes. If you use a good mold steel, it can reach 500,000 strokes. The mold suggestion is to make a single engineering mold and not a composite mold, unless you have a strong mold repairer.
Selection and use of steel toe shoes
1. In addition to choosing a suitable type of steel-toed shoes according to the operating conditions, they should also fit the feet and make people feel comfortable to wear. This is very important, and the appropriate shoe size should be carefully selected.
2. The steel-toed shoes should have a non-slip design, not only to protect the feet of people from injury, but also to prevent accidents caused by the operator being slipped.
3. Various protective shoes with different performances must meet the technical indicators of their respective protective performances, such as the toes are not injured, the soles of the feet are not punctured, and the insulation and conductivity are required. But safety shoes are not a panacea.
4. Check or test carefully before using steel-toed shoes. In electrical and acid-base operations, damaged and cracked protective shoes are dangerous.
5.The steel-toed shoes should be kept properly after use, and the rubber shoes should be washed with water or disinfectant and dried to extend the service life.
If you need to manufacture labor insurance shoe steel head molds, please contact us, our price is reasonable and the mold quality is good
Industry knowledge
Aluminum stamping, metal stamping parts, common problems that should be paid attention to during processing and the methods to solve the problems
1. If you want to make aluminum stampings well and reduce the defect rate, you must first do 5S, especially cleaning, including molds, punching tabletops, assembly lines and packaging materials must be free of sharp debris, no dirt, and regular and clear rectification , The mold must be cleaned up and down without debris.
2. If the product has large burrs, it must be sent to the mold for repair in time and follow up to the result.
3.Aluminum parts are more likely to heat up and become hard when they are stacked together. Therefore, when punching and blanking, it is necessary to apply a little pressure oil on the material (which can dissipate heat and smoothly dredge the blanking) and then press.
4. For products with more punching holes, you need to clean the surface of the mold to ensure that the mold and the product are always clean and free of debris, and the top damage is reduced. If the top damage is found, the problem of the top damage of the mold must be found and solved before proceeding. produce.
5. Pushing the mold and pushing block will produce aluminum scraps, so the aluminum scraps under the pushing block must be cleaned after the production of the pushing block every day.
Hot Tags: industrial safety shoes mould, China, suppliers, manufacturers, factory, buy, price, made in China, Anti smashing Shoe Steel Toe Cap Mould, Labor Insurance Shoes Steel Toe Cap Mould
